Trouble Shooting Guide - Napoleon HYBRID 150 Operating Instructions Manual

62
11.0

TROUBLE SHOOTING GUIDE

SYMPTOM
Smoke enters the
room during start-up.
Kindling does not start
- fire smolders.
Smoke enters the
room while re-loading.
Appliance does not
burn hot enough.
Blower does not run.
Appliances does not
burn overnight.
Appliance smoking.
W415-0910 / A / 09.16.10
PROBLEM
Cold air blockage in chimney.
Close the doors.
Cold air blockage in chimney.
Not enough starter paper.
Not enough air.
Insufficient draft.
Wood is wet.
Insufficient draft.
Primary air control is not
functioning.
Appliance is not up to temperature.
Electricity is cut to the blower.
The doors are not sealing.
TEST SOLUTION
- Burn a piece of newspaper to establish a draft.
- If the flame is not getting enough air, first make sure the air control is
open. If additional air is needed, open the doors a small crack only.
- Burn a piece of newspaper to establish a draft.
- Use additional newspaper if necessary.
- First make sure the air control is fully open. If additional air is
needed, a small crack in the doors is all that is needed.
- Chimney height and outside conditions can negatively affect draft. In
these cases a small amount of smoke may enter the home. Adding
more pipe or a draft-inducing cap may help.
- See the section on "Selecting Wood" for details.
- Chimney height and outside conditions can negatively affect draft. In
these cases a small amount of smoke may enter the home. Adding
more pipe or a draft-inducing cap may help.
- With the electric power confirmed to the furnace and the thermostat
turned up full, check that the control arm is at bottom of slot in the
primary air control housing.
- If the arm is not near the bottom of the slot, the primary shutter may
be stuck or the motor is malfunctioning.
- This is normal. The blower will come on when the furnace
supply plenum is heated up enough to turn on fan limit.
- Check the household breaker or fuse to make sure it is operable.
- See the section "Door Glass / Gasket Replacement" for details.
- Demand from thermostat constantly exceeding output of the
furnace.
- Primary air shutter always in the full open position.
- Has the chimney had time to get hot?
- Is there adequate supply of combustion air?
- Is the outside air damper opened?
- Is the smoke passage blocked anywhere in the appliance or
chimney?
- Is the smoke flow impeded by too long of a horizontal pipe or too
many bends?
- Is it a weak draft perhaps caused by a leaky chimney, a cold outside
chimney, too short a chimney, or a chimney too close to a tress or a
higher roof?