Buttons - Pfaff expression 150 Owner's Manual

Buttons

4
1
3
2
1
4
5
6
Thread tension dial (1)
If needed, adjust the top thread tension using the
markings on the tension dial.
Needle up/down with indicator (2)
Press this button to move the needle up or down.
The set ting of the needle stop po si tion is changed
at the same time. When needle down is activated,
the indicator is lit, the needle will stop in the down
position.
You can also tap the foot control to raise or lower
the needle.
Speed control (3)
Press the speed button to reduce the sewing
speed by half. An icon on the graphic display will
indicate that your machine is set to half speed.
Press the speed button again to resume full speed.
Reverse (6) with indicator (4)
For permanent reverse, press the button
before starting to sew. The reverse indicator (4)
will be lit and the machine sews in reverse until
you press the button again to cancel.
If you press the reverse button while sewing, the
machine sews in reverse for as long as you keep the
button pressed. The reverse indicator is lit when
the reverse button is pressed.
Reverse is also used when sewing buttonholes,
programmed tie-off end and darning stitches to
step between the parts of the stitch.
18 - Preparations
2 3 7 8 10 9 11 12
14 15 16 17
Programmed tie-off indicator (5)
The programmed tie-off indicator is lit to indicate
that one or several tie-off options are activated. The
indicator stays lit until the tie-off options are no
longer in use.
Immediate tie-off (7)
Press the tie-off button while sewing and your
machine sews a few tie-off stitches and stops
automatically.
Graphic display (8)
The graphic display lets you view all your
selections and options. Stitches are shown in real
size.
Stitch width or stitch positioning (9)
Increase or decrease the stitch width using the +
and - buttons.
Press the alternatives button (11) to view the stitch
positioning for the selected stitch. Use the + and -
buttons to change the stitch position.
Stitch length or stitch density (10)
Increase or decrease the stitch length using the +
and - buttons.
Press the alternatives button (11) to view the
density setting for satin stitches. Use the + and
- buttons to change the density for the selected
stitch.
13