Pfaff expression 150 Owner's Manual page 29

To make piping from your fabric:
1. Cut bias or crosswise grain strips, wide enough
to cover the cording plus seam allowances.
2. Lay the cording on the wrong side of the fabric
strip and wrap the fabric over the cord.
3. Place the fabric and cord under the Piping Foot
with the cord in the groove on the underside of
the foot.
4. Stitch. The groove will guide the cord so the
fabric covers evenly.
TIP: When you sew this piping into a garment, adjust
the needle position so it stitches one setting closer to the
cord to cover the rst stitching.
Decorative trim foot
Embellish your project with different types of trims
by using the Decorative trim foot. This foot will
easily guide the trims through the opening at the
front and through the groove under the presser
foot.
1. Thread your machine with a regular sewing
thread or decorative thread on top and regular
sewing thread in the bobbin.
2. Select a straight stitch, zigzag stitch or
decorative stitch. Avoid using stitches with too
much back and forth motion.
Tip: For the 6mm wide trims, you can also use a 6mm
twin needle. Select a straight stitch and it will sew at the
edges of the trim.
3. Place the trim in the presser foot as the picture
shows.
4. Snap on the Decorative Trim Foot.
Engage the IDT™ system.
5.
6. Sew carefully, not too fast. (You might need
stabilizer underneath the fabric)
7. The best result is achieved if you use at trims,
such as silk, velvet, satin or cotton ribbons.
3 mm 6 mm
(1/8") (1/4")
12 mm
(1/2")
Sewing - 29