Placing Calls - NEC Xen Topaz User Manual

If your call doesn't go through...
Checking & Answering a Message Waiting Indication
You can check who left a message waiting indication for you, and then answer.
CHECK
8
(On-Hook)
Applicable to Display System Phones only.
Cancelling a Message Waiting Indication (at originating extension)
you want to cancel MW
CALL
8 7 1
Clearing All Message Waiting Indications (at any extension)
CALL
8 7 3
Clears all messages you have left for other extensions and messages other extension have left for you.
Repeat Dialling <Outside Call>
DC LND
(Hear Busy Tone Repeat Dial Key
or No answer)
(SC.851+29)
[Flashes red when set.]
[Press flashing key to cancel.]
The system periodically redials the call. Repeat duration is programmable. Ask your NEC Authorised
Supplier for details.
You should lift the handset when the called party answered.
You can cancel this function by pressing "DC" and "LND" during idle condition.
Does not reserve line. Will select other available line when original line is in use.
VOL
4 1
(Check Name)
Extension Number
SPK
? ? ?
SPK
8

Placing Calls

Placing an Outside Call <Quick Access>
Telephone Number
Trunk Key
? ? ? ?
Listen for Dial Tone before dialling a Telephone Number.
You can have function keys for Trunks or Trunk Groups. Ask your Supplier.
Placing an Outside Call <Access Code>
CALL Trunk Code Telephone Number
0 ? ?
Listen for Dial Tone before dialling the Telephone Number.
Placing an Intercom Call <Dial Access>
Extension Number
CALL
? ? ?
Pressing CALL key after dialling an extension number is also possible.
Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialling "1" changes voice/ring mode (where the destination is a System Phone).
Using One-Touch Keys <Outside/Intercom Calls>
One-Touch / DSS Key
The Telephone / Extension Number shall be pre-registered to a One-Touch / DSS Key (refer to Page 2).
Trunk Access Code (Dial "0") should be added as the first digit of the Telephone Number.
? ?
5