Fault Codes - Pride Mobility Power Glide Basic Operation Instructions

Basic Operation Instructions

FAULT CODES

The status LED will flash fault codes when the Power Glide detects an abnor-
mal condition in the electrical system. The status LED will continue to flash
the fault codes until the problem is fixed. The table below identifies the indi-
vidual fault codes. If any of these fault codes persist, contact your authorized
Pride Provider.
Flash Probable
Code
1 Battery needs
recharging
2 Battery volt-
age too low
3 Battery volt-
age too high
4 Current limit
time out
7 Throttle/speed
potentiometer
error
9 Internal error
Cause
Will drive
Drive inhibited Battery is fully discharged.
Drive inhibited Battery charge is too high.
Drive inhibited The device has drawn too
Drive inhibited The wiring may be faulty.
Drive inhibited Contact your authorized
www.pridemobility.com
Impact
Battery charge is running
low. Recharge the battery
as soon as possible.
Recharge the battery.
Excessive charging can
cause this fault.
Check the battery connec-
tions.
much current for too long,
possibly due to a shorted
motor. Turn the device off
for a few minutes, then turn
back on. Check the motor
for shorts. Contact your
authorized Pride Provider if
the problem persists.
Contact your authorized
Pride Provider.
Pride Provider.
Possible
Solution
Power Glide
19