Pride Mobility Power Glide Basic Operation Instructions page 12

12
9. Fit the control module bracket to one of the back canes of the wheelchair,
making sure that the seatback does not touch the controller bracket when
the seatback is reclined, if equipped. Tighten the hardware. See figure 4.
10. Place the battery pack on the powerpack. See figure 5.
11. Connect the battery plug on the powerpack to the plug on the battery.
See figure 5.
12. Route the cable from the powerpack up along the seatback and connect
the socket from the powerpack to the control module. See figure 6.
13. Attach each holding strap to the bottom of the wheelchair frame as
shown in figure 6.
14. Route the holding straps over the top of the installed Power Glide and
secure them with reusable hook and loop fasteners.
NOTE: The holding straps cannot be installed on all models of wheelchairs.
Screws
Figure 4. Controller Bracket Installation
Figure 5. Battery Pack Installation
Power Glide www.pridemobility.com
Basic Operation Instructions