Operation Of The Power Glide - Pride Mobility Power Glide Basic Operation Instructions

14
To install the handle extensions:
1. Remove the hand grip from the back cane.
2. Pry off the cap that covers the setscrews on the handle extension.
3. Loosen the setscrews.
4. Install the handle extension so that the flat side of the handle extension
is against the controller bracket. See figure 4 and figure 6.
5. Tighten the setscrews.
6. Reinstall the cap.
7. Install the handle extension on the other back cane following the above
steps.

OPERATION OF THE POWER GLIDE

Figure 7 provides information on the Power Glide control module
components. Use this diagram to familiarize yourself with the function and
location of each component before using the Power Glide.
Forward/
Reverse
Switch
On/Off Key
Figure 7. Control Module Components
On/Off Key
The on/off key turns the system on and off.
NOTE: The wheelchair can be pushed when the Power Glide system is off.
Status LED
The status LED illuminates when the on/off key is in the on position and
also flashes fault codes. See "Fault Codes."
Power Glide
Speed
Dial
www.pridemobility.com
Basic Operation Instructions
Status LED
Throttle Lever