Gc Diagnostic Fault Codes - Pride Mobility Jet 3 Ultra Troubleshooting Manual

What if my Jet 3 Ultra begins pulling to one side?
! Determine if the joystick is being deflected straight or at a slight angle. Even a small amount of deflection
right or left will cause the chair to veer over a long distance.
! Determine if both manual freewheel levers are in the drive position. If only one manual freewheel lever is
in the drive position, the other motor will not operate and the Jet 3 Ultra will veer severely.
! Determine if both tires are inflated to the proper psi if the power chair is equipped with pneumatic tires.
Pneumatic tires should be inflated to 35 psi (2.4 bar). If one tire is inflated more than the other, the power chair
will pull to the side that is underinflated.
What if the Jet 3 Ultra powers up, but will not move?
! Determine if both manual freewheel levers are in the freewheel position. If the power chair is in freewheel
mode, then the electronics will function but the motors will not spin the wheels.
! Determine if the controller is flashing a fault code. The Jet 3 Ultra comes equipped with either a GC or VSI
controller. Each controller will flash a code via the battery condition meter LEDs if a system fault is detected.

GC DIAGNOSTIC FAULT CODES

FAULT CODE PROBABLE CAUSE(S)
1 Flash The batteries need charging.
There is a bad connection to the batteries.
2 Flashes There is a bad connection on the left motor. Check the left motor connections and wiring
3 Flashes The left motor has a short to a battery
connection.
4 Flashes There is a bad connection on the right
motor.
5 Flashes The right motor has a short to a battery
connection.
Rippling LEDs The charge inhibit has been activated.
7 Flashes There is a joystick fault.
8 Flashes There is a control system fault.
9 Flashes The park brakes have a bad connection.
10 Flashes An excessive voltage has been applied to
the control system.
INFINFB2045/Rev A/12-04-06
B T
ASIC ROUBLESHOOTING
www.pridemobility.com
I : J 3 U
NSTRUCTIONS ET
POSSIBLE SOLUTION
Check the battery connections. If the battery
connections are good, then try charging the
batteries.
harnesses.
Contact your authorized Pride Provider.
Check the right motor connections and wiring
harnesses.
Contact your authorized Pride Provider.
Make sure that the battery charger is not
connected to the power base.
Make sure the joystick is in the center position
and then power off and on again.
Check power module and joystick module
connections and wiring.
Check the left and right motor connections and
wiring.
Check the battery connections.
LTRA
2