Using the Numeric buttons
CHANNEL 1–9
CHANNEL 10
CHANNEL 11–16
Changing the Remote Control ID
Remote control's ID and DVR's ID should be matched for proper operation.
1. Press the [ID] button of the remote control and check the ID displayed on the DVR screen.
The factory default ID of the remote control is 00.
2. Enter 2 digits of your selection in order, while pressing the [ID] button of the remote control.
3. When ID input is done, press the [ID] button of the remote control again to check the setting.
M
If you want to change the remote control ID to 08: Press 0 and 8 in order while the [ID] button of the remote control is
pressed.
For changing the ID of remote device, refer to "Remote Devices". (Page 47)
Press each button between 1 to 9.
Press the [+10] button first, then press the 0 button again within 3 seconds.
Press the [+10] button first, then press any number between 1 to 6 within 3 seconds.
English _13