Table of Contents
Advertisement
NORMAL OPERATION
To dispense ice, hold a cup directly under the ice chute, then press the appropriate size button on the ice por-
tion control. To obtain a full cup of ice, press the increase button followed by the appropriate size button. The ice
portion control will not dispense ice and will display a flashing green indicator light if sufficient ice is not avail-
able in the ice chute to dispense the selected size. The indicator light will return to solid green and ice dispens-
ing will resume after the ice chute has been filled.
The amount of ice dispensed for each size is changed in the Normal and Extra Ice Adjustment Modes. To ac-
cess the adjustment modes, press the decrease and increase button at the same time. The control will advance
to the next mode in the sequence as shown in the table on page 6 and the indicator light will change to identify
which mode is currently active.
CLEAN MODE
Access this mode when cleaning the ice chute. Refer to Cleaning Instructions on pages 7 thru 9.
NORMAL ICE PORTION ADJUSTMENT
From the Normal Operation Mode (green indicator), press both the decrease and increase buttons at the same
time twice. The amber indicator verifies that the normal portion adjustment mode has ben accessed.
To change the amount of ice dispensed, press and hold down the size button for the desired size to be
changed. While holding the size button, press the decrease or increase button to decrease/increase the ice por-
tion size. When the minimum ice portion adjustment has been reached, the indicator will flash at a slow rate; at
the maximum adjustment, the indicator will flash at a fast rate. After releasing the size button, the indicator light
will flash green for five seconds. During this time period a sample can be obtained to check the portion size by
pressing the size key. The indicator light will return to amber (normal portion adjustment mode) after the sample
is dispensed.
The indicator light will flash red after dispensing a sample, if an open circuit exists in the ice gate cylinder switch
wiring to the ice portion control or if an ice gate binding condition occurred during the sample. The indicator light
will display solid red briefly after a sample is dispensed if the ice gate cylinder switch was shorted.
To return to normal operation press the decrease and increase buttons at the same time, press twice.
AGITATION REFILL TIME ADJUSTMENT
To adjust the amount of ice chute refill agitation. begin by accessing the Extra Ice Portion Adjustment Mode
(red Indicator). Next, press and hold for the decrease and increase buttons for three seconds until the indicator
flashes amber. The indicator will flash up to four times, one flash corresponds to the minimum amount of refill
agitation and four flashes corresponds to the maximum amount of refill agitation. Change the amount of refill
agitation by pressing one of the four size buttons -- the small button representing the minimum amount of refill
agitation. Increase the amount of refill agitation if the ice chute does not refill properly after dispensing ice.
To return to Normal Operation Mode, press the decrease and increase buttons at the same time.
MANUAL ICE DISPENSING OPERATION
A pushbutton switch is provided on the upper front panel (see Figure 1) to manualy dispense ice. This system
can be used in the event of a malfunction with the ice portion control or for dispensing ice in portions other than
cup-size. Depress and hold the pushbutton until the desired amount of ice is dispensed.
If a problem with the Air/CO
upper front panel. The function of this valve is to remove Air/CO
malfunction occur. Move the valve toggle switch to the " manual"position (to the right) and push the gate back to
its open position. Ice can now be dispensed by depressing the manual ice dispense. switch. When the problem
with the Air/CO
system has been corrected, move the toggle switch left to the " auto"position to restore the unit
2
to the ice portioning mode of operation.
CAUTION: The gate closes immediately when the toggle switch is moved to the auto
position. Do not place fingers or foreign objects into the ice chute when operating the
toggle switch.
ice gate system should occur, a manual air valve is located on the right side of the
2
pressure on the ice gate should a gate
2
7
620906904
Advertisement
Table of Contents
