Changing Units; Leaving Units Setup - Raymarine ST70+ Installation Manual

26
• Wind speed to either knots or meters per second.
• Heading to either magnetic or true.
• Flow rate to either US gallons per hour, UK gallons per hour or liters per hour
• Temperature to degrees Celsius or degrees Fahrenheit.
• Pressure to pound per square inch or kilo Pascals.
• Volume to either US gallons, UK gallons or liters
• Number of engines to either 1, 2, 3, 4 or 5.
• Number of batteries to either 1, 2, 3, 4 or 5.
• Number of fuel tanks to either 1, 2, 3, 4 or 5.
OK
Press to see the second Units summary page, and if you want to return to the first
page from the second, press
Check the information on the Units summary
pages, then with the second Units summary page
displayed, press
menu.
If you want to change any data units, carry out the
Changing units procedure below.
If you do not want to change any data units,
proceed from Leaving units setup below.

Changing units

To change any data units:
1. With the Select units menu displayed, scroll to select the type of data you want to
change, i.e. Speed, Depth, Distance, Wind Speed etc.
OK
2. Press
units you have selected.
3. Scroll to select the required units.
OK
4. Press
the first Units summary page.
OK
5. Press
menu.
6. If you want to change any other units, repeat
steps 1 to 5 of this procedure.

Leaving units setup

When your data units are set as required:
1. With the Select units menu displayed, scroll to
the Continue option.
OK.
2. Press
Initial setup now ends.
CANCEL
OK
to display the Select units
to display the setup page for the
to save the units setting and return to
twice, to display the Select units
:
ST70+ User Reference Manual
.
Select units
Select units to change, using <
i
or >.
Wind Speed Units
Select required units, using < or
i
>. CANCEL exits without saving
Select units
Select units to change, using <
i
or >.
Wind Speed Units
Press OK to select
KTS
Press OK to accept
Continue
Press OK to select