Setting Local Time; Leaving Date & Time Setup; Data Units - Raymarine ST70+ Installation Manual

Chapter 3: Commissioning Procedures
2. Scroll to the required Time Format, then press
OK
to save the format and return to the Time &
Date summary page.
OK
3. Press

Setting local time

Note:
If your ST70+ display is connected to a Raymarine multi-
function display, then the time offset is controlled by the
multifunction display and you cannot use this procedure
to change it.
To set the display time to your local time.
1. At the Time & Date setup menu, use
select the Set time offset option, then press
to display the Set time offset page.
2. Scroll to set the correct local time. For exam-
ple, if your local time is 1 hour after GMT, set -1.
OK
3. Press
Time & Date setup menu.
Leaving date & time setup
When your date and time formats and values are
set as required:
1. At the Time & Date setup menu, scroll to the
Continue option.
OK
2. Press
page.
3. Proceed from Data units (below).

Data units

The Units summary comprises two pages and
shows units currently in use. You can accept all or
change any of the data unit settings. You can set:
• Speed to either miles per hour, kilometers per
hour or knots.
• Distance to either miles, nautical miles or
kilometers.
• Depth to either feet, fathoms or meters.
to select the Time & Date setup menu.
, to save the setting and return to the
to proceed to the Units summary
Set time format
Use < & > to adjust.
i
CANCEL exits without saving.
Time & Date
< >
and to
OK
,
Set time offset
Use < & > to adjust.
i
CANCEL exits without saving.
Time & Date
Units summary
These are your current settings.
i
Press OK to continue
12-hour
Press OK to accept
Set time offset
Press OK to select
-1 hour
Press OK to accept
10
Continue
Press OK to select
6 pt
Speed KTS
Distance
Depth
Wind Speed KTS
Heading Mag
Flow Rate G/H
Temperature
25
NM
FT
C
o