Date & Time; Setting Date Format; Setting Time Format - Raymarine ST70+ Installation Manual

24
Date & Time
The Time & Date summary page shows the current
values applied to your ST70+ system.
Note:
If your display is not receiving GPS information, the Time
& Date page is not displayed. In this case, proceed with
the Data units setup procedure below.
Check the information, on the Time & Date summary
page, then press
setup menu.
You can change certain date and time parameters. You can:
• Select either dd/mm/yy or mm/dd/yy as the date format
• Select either 12-hour (am/pm) or 24-hour as the time format.
• Set the value of the time offset to give the required local time.
If you want to change any Time & Date values, carry out the Setting date format,
Setting time format and/or Setting local time procedure below, as appropriate.
If you do not want to change any Time & Date values, proceed from Leaving date &
time setup below.

Setting date format

To set the required date format:
1. At the Time & Date setup menu, scroll to the Set
date format option, then press
the Set date format page.
2. Scroll to select the required Date Format, then
OK
press
Time & Date summary page.
OK
3. Press

Setting time format

To set the required time format:
1. With the Time & Date setup menu displayed,
scroll to select the Time Format option, then
OK
press
OK
to display the Time & Date
to save the format and return to the
to select the Time & Date setup menu.
to display the Set time format page.
ST70+ User Reference Manual
Time & Date
i
Time & Date
OK
to display
Set date format
i
Time & Date
Time
10
Date
Time Offset
Time Format
Date Format dd/mm/yy
Press OK to continue
10
Set date format
Press OK to select
10
dd/mm/yy
Use < & > to adjust.
CANCEL exits without saving.
Press OK to accept
10
Set time format
Press OK to select
11:01:03
14/06/07
-1 Hrs
24-hour