Table of Contents
Advertisement
User guide
CANMAX400 Standalone
Before remote starting a manual transmission vehicle, be sure to:
•
Leave the vehicle in neutral and be sure no one is standing in front or behind th
•
Only remote start on a flat surface
•
Have the parking brake fully
Use of this product in a manner
or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the
keys in the ignition. The u
ser must also have the neutral safety feature of the vehicle periodically checked, wherein the
vehicle must not remotely start while
in accordance with the Safety Check
start operation immediately and consul
After the remote start module has
module by performing the Safety Chec
Neutral Safety Shutdown Circuit test, the
be rem
oved or the installer must properly reinstall the remote start system so that the
installations must be performed by an authorized Directed dealer.
OPERATION OF THE REMOTE START MODULE IF THE VEHICLE STA
INTENDED MODE OF OPERATION. OPERATING THE REMOTE START SYSTEM UNDER THESE CONDITIONS MAY
RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IM
UNIT AND SEEK TH
E ASSISTANCE OF AN AUTHORIZED Directed DEALER TO REPAIR OR DISCONNECT THE
INSTALLED REMOTE START MODU
INSTALLATION OR REINSTALLATION COSTS.
Using the remote starter
Remote starting your vehicle
•
Press the
button on the remote control. The vehic
•
On the 2-way remote, the Remote Start
The preset remote start run time is 12 minutes. This can be changed to between 12 and 60 minutes (see your authori
dealer for programming changes).
Points to remembe
If the hood is open or is the brake pedal is pressed, the vehicle will not start using remote start. The remote starter shuts
down:
•
When the brake pedal is pressed.
•
The hood is opened.
•
If the alarm is triggered when armed.
•
When the Re
mote Start command is sent again from a remote control.
© 2009 Directed Electronics, Inc. All rights reserved.
engaged
contrary to its intended mode of operation may result in property damage, personal injury,
the car is in gear. This testing should be performed by an authorized Directed dealer
outlined in the product installation guide. If the vehicle starts in gear, cease remote
t with the authorized Directed dealer to fix the problem.
been installed, contact your authorized dealer to have him or her test the remote start
k outlined in the product installation guide. If the vehicle starts when performing the
remote start unit has not been properly installed. The remote start module must
LE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR PAY FOR
indicator blinks and ascending Remote Start tone plays.
r
e vehicle.
RTS IN GEAR IS CONTRARY TO ITS
MEDIATELY CEASE THE USE OF THE
le parking lights flash.
Revision: 16-Nov-09
vehicle does not start in gear. All
zed
9
Advertisement
Table of Contents
