Directed Electronics ProStart CT-5472TW User Manual
  1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Remote Starter
  5. ProStart CT-5472TW
  6. User manual

Directed Electronics ProStart CT-5472TW User Manual

Two­-way 6­-button lcd automatic/manual transmission remote starter system with full alarm system
Hide thumbs
Table of Contents

Advertisement

Quick Links

TWO­WAY 6­BUTTON LCD AUTOMATIC/MANUAL TRANSMISSION  
Depending on the usage, the transmitter's battery can last between 3 to 6 months. When the battery is low, the
transmitter will emit two "beeps" in a repetitive cycle. At that point the batteries should be replaced. We
recommend keeping a spare battery somewhere handy such as inside the glove compartment.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 110829
Rev: 1.3
REMOTE STARTER SYSTEM WITH FULL ALARM SYSTEM 
CT-5472TW
User Guide
It is the responsibility of the vehicle operator to ensure that their vehicle is parked in
a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's responsibility
to ensure that the gearshift lever is in the NEUTRAL position and the parking
brake is engaged in order to avoid accidents upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to avoid
accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled or put
into valet mode before servicing.
The Transmitter's Battery:
© 2011
WARNING!
-CT-5471TW-
-FcN-
Canada

Advertisement

Table of Contents
loading

Related Manuals for Directed Electronics ProStart CT-5472TW

Summary of Contents for Directed Electronics ProStart CT-5472TW

  • Page 1 TWO­WAY 6­BUTTON LCD AUTOMATIC/MANUAL TRANSMISSION   REMOTE STARTER SYSTEM WITH FULL ALARM SYSTEM  CT-5472TW User Guide WARNING! It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner. 1. a) Manual transmission: When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged in order to avoid accidents upon remote starting.

  • Page 2: Table Of Contents

    Table of Content INTRODUCTION WITH SMARTSTART™ ................3   VEHICLE PRESETS .......................... 3   & H ......................... 3   EATER EATED & H ..................3   INDSHIELD IPERS ADIO EADLIGHTS USING THE REMOTE CONTROL ..................... 3   LCD R ........................ 3  ...

  • Page 3: Introduction With Smartstart

    Introduction with SmartStart™    This is a state-of-the-art remote car starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features), the Safe Start children safety feature and SmartStart™. SmartStart™ is a groundbreaking technology that enables your remote starter features to be accessed by your smartphone.

  • Page 4: Basic Vehicle Operations

    The functions of the transmitter are as follows: LOCK: Locks the doors and arms the system. Arms the Starter Kill (if installed). UNLOCK: Unlocks the doors and disarms the system. Disarms the Starter Kill (if installed). TRUNK: Opens the TRUNK and disarms the system. Note: Trunk option must be installed.

  • Page 5: How To Access Remote

    How to access remote’s function menus:  User Transmitter appears on screen. 1. Press until the remote beeps once Remote beeps once and 2. Press time for 2 second and release appears on screen. Remote beeps once and 3. Press time for 2 second and release appears on screen.

  • Page 6: Remote-Starting Your Vehicle

    Remote­Starting Your Vehicle  Setting Your Vehicle Into Ready Mode  If your vehicle has a manual transmission you must read the following indications. The unit must first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready Mode, it cannot remote start the vehicle.

  • Page 7: Driving Off

    Driving Off  With the vehicle running remotely, press the button to disarm the starter kill (if installed) and unlock the doors. Enter the vehicle and do the following: Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK position while the engine is running.

  • Page 8: Remote Trunk Release

    To LOCK your doors and ARM the system: Press and hold the button for approx. 1 sec. icon will appear on the remote’s LCD screen The siren will chirp once to confirm that the doors have been locked, the Starter Kill feature is enabled (if it was installed) and that the Alarm is armed.
  • Page 9 Ignition Valet: This feature allows you to set Valet Mode using the ignition key. Remote valet: This feature allows you to set Valet Mode using the transmitter. Valet switch: This feature allows you to set Valet Mode using a push button switch (optional). To put the system into Valet Mode Using the KEY (Ignition Valet Mode): Insert the ignition key into the ignition switch.

  • Page 10: Panic Mode

    Panic Mode  In an emergency situation, you can activate panic mode by pressing and holding the button until the siren starts to sound.. If the vehicle is under a remote start, the engine will shutdown automatically before setting off the Siren. You can stop the Siren by pressing: (this will lock your doors and deactivate panic mode), or (this will unlock your doors and deactivate panic mode).

  • Page 11: Intrusion Codes Via Led Light

    Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle has been running for 2 minutes already, pressing the button will reset the counter to zero and allow the engine to run for another cycle (in this case, 3 minutes). Intrusion Codes via LED light ...

  • Page 12: Advanced Features: Installation-Programmable Options

    Advanced Features: Installation­programmable Options  The Remote Car Starter was designed with flexibility and OEM integration in mind. With its programmable options, this unit can single-handedly control nearly any electrical system in your vehicle. Caution: The programming of your system should be left to a professional. Changing any one of the settings may affect the operation of your Remote Car Starter.

  • Page 13: Engine Run Time

    Safe start enabled: If this feature is enabled, the user must press the button twice within 3 seconds to remote-start the vehicle. Swap start: If this feature is enabled; Press the for 1 second and release. The remote will beep once and will appear on the display.

  • Page 14: Arming

    • If an intrusion was detected, the siren will 4 times if is pressed. The system can alternatively be set to: (must be configured by the installer) • Warning Mode (no chirp during lock/unlock – unless one of the doors, the hood or the trunk is open.

  • Page 15: Relock

    • Press : ..............LOCK • Press : ..............UNLOCK • Press : ..............START • Press : ..............STOP • Press : ............ TRUNK • Press : ..........LOCK • Press : ..........UNLOCK • Press : ..........START •...
  • Page 16 Your installer can add customized features such as turning on the radio, opening sliding doors, etc................... customized feature 1 ..................customized feature 2 : ................... customized feature 3 ..................customized feature 4 Accessing the Multi-Level Features and Other Transmitter Functions To access a Level 1 feature, press and hold the button until you hear a “beep”;...

  • Page 17: Diagnostics - Parking Light Flash Table

    Level 1 (requires pressing the button 1X) Basic features Level 2 (requires pressing the button 2X) Customized features Level 3 (requires pressing the button 3X) Multi car operation Example: If the multi-level features was set to option 3, the setup would be as follows: For “basic features”: - To access the aux.

  • Page 18: Poor Transmitting Range Issues

    Poor Transmitting Range Issues  Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…) • Metal: any type of metal will affect operating range. This includes the metal in the car. •...

  • Page 19: Prostart Limited Lifetime Warranty

    Directed will provide to the original consumer purchaser a repaired or refurbished remote starter module, for a repair and shipping/handling charge of $45.00 plus applicable taxes, a cheque or money order made payable to DIRECTED ELECTRONICS, CANADA INC must accompany the remote starter module. A module will be returned to the consumer, freight prepaid, within 4 weeks of receipt of the module.

Table of Contents