CONNECTING THE FEEDER CABLE
To connect the feeder cable to the hob it is necessary to carry out the following opera-
tions:
•
Unscrew the screw A of the terminal board at the bottom of the hob (fig. 4.1).
•
Unlock the 2 clips B and open the cover C.
• Unscrew the screw D and open completely the cable clamp E
•
Position the U bolts F onto terminal board G (fig. 4.3) according to the diagram in fig. 4.2.
•
Connect the phase and earth wires to terminal board G according to the diagram in
figs. 4.2 and 4.3.
•
Strain the feeder cable and block it with cable clamp E (by screwing screw D).
•
Close the cover C of the terminal board G and block it with the screw A.
FEEDER CABLE SECTION
"Type H05VV-F or H05V2V2-F or H05RR-F"
~
220-240 V
3 x 2,5 mm
~
220-240 V
3 x 4 mm
(**) Connection with wall box connection.
– Diversity factor applied
– A diversity factor may be applied to the total loading of the appliance only by a suit-
ably qualified person
2
(**) for 60 cm and 80 cm models
2
(**)
for 90 cm models
C
G
L
F
(fig.
4.3).
E
N
D
E
Fig. 4.3
19