Steady Shot Check - Sony DCR-DVD100 Service Manual

DCR-DVD100/DVD100E

16. Steady Shot Check

Precautions on the Parts Replacement
There are two types of repair parts.
Type A: ENC03MA
Type B: ENC03MB
Replace the broken sensor with a same type sensor. If replace with
other type parts, the image will vibrate up and down or left and
right during hand-shake correction operations.
Precautions on Angular Velocity Sensor
The sensor incorporates a precision oscillator. Handle it with care
as if it dropped, the balance of the oscillator will be disrupted and
operations will not be performed properly.
Subject
Measurement Point
Measuring Instrument
Specified Value
Note1: Displayed data of the adjustment remote commander.
1 : XX : XX
Note2: The data of page: 0, address: 10 must be "00".
Switch setting:
1) STEADY SHOT (Menu setting) ....................................... ON
2) ZOOM .................................................................... TELE end
Adjusting method:
Order Page Address Data
1 0 03
2 1
3 0 03
4 1
5 0 03
6
Note3: Don't move the camcoder.
Arbitrary
Display data of page 1 (Note1)
Adjustment remote commander
2B00 to 4B00
Display data
Procedure
Pitch sensor check
(MA-420 board SE5502)
11 Set the data.
Check that the display data
(Note1) satisfies the specified
value. (Note3)
Yaw sensor check
(MA-420 board SE5501)
12 Set the data.
Check that the display data
(Note1) satisfies the specified
value. (Note3)
00 Set the data.
Move the camcorder, and check
that the steady shot operations
have been performed normally
6-26