License Plate Lamp - Chevrolet Impala 2014 Owner's Manual

10-34 Vehicle Care
Caution
Improper lamp assembly removal
and installation can cause leaks
and water intrusion which may
cause damage to the taillamp. Do
not remove the taillamp assembly
to replace a bulb. Use the trunk
opening to access the bulb.
To replace one of these bulbs:
1. Open the trunk. See Trunk on
page 2-14.
2. Remove the push pins and pull
the trunk trim away from the
taillamp assembly.
3. Remove the bulb socket from
the taillamp assembly by turning
it counterclockwise.
4. Remove the bulb from the
socket by turning the bulb
counterclockwise one-quarter
turn and pulling it straight out.
5. Install a new bulb into the
socket.
6. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
7. Install the trunk trim and
push pins.

License Plate Lamp

To replace one of these bulbs:
Passenger Side Shown, Driver
Side Similar
1. Push the lamp assembly toward
the right.
2. Pull the lamp assembly down to
remove.
3. Turn the bulb socket (1)
counterclockwise to remove it
from the lamp assembly (3).
4. Pull the bulb (2) straight out of
the bulb socket.
5. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install it into the lamp assembly.
6. Push the lamp assembly back
into position until the release tab
locks into place.