Chevrolet Impala 2014 Owner's Manual page 66

3-8 Seats and Restraints
Storing Memory Positions
To save positions to the 1 and 2
buttons:
1. Adjust the driver seat, outside
mirrors, and the power tilt and
telescoping steering column (if
equipped) to the desired driving
positions.
2. Press and holdSET and 1 at
the same time until a beep
sounds.
3. Repeat Steps 1 and 2 for a
second driver using 2.
To save positions to the
button and easy exit features:
1. Adjust the driver seat, power tilt
and telescoping steering column
(if equipped), and the outside
mirrors on some vehicles to the
desired positions for getting out
of the vehicle.
2. Press and hold SET and
the same time until a beep
sounds.
Manually Recalling Memory
Positions
If the vehicle is off, or in ON/RUN/
START but not in P (Park), press
and hold "1," "2," or
recall the previously stored memory
positions. Releasing "1, "2," or
before the stored positions are
reached stops the recall.
If the vehicle is in ON/RUN/START
and in P (Park), press and release
1, 2, or
previously stored memory positions.
Placing the ignition in OFF before
(Exit)
the stored positions are reached
stops the recall.
If something has blocked the driver
seat and/or power tilt and
telescoping steering column (if
equipped) while recalling a memory
position, the recall may stop.
Remove the obstruction; then press
and hold the appropriate manual
at
control for the memory item that is
not recalling for two seconds. Try
recalling the memory position again
to manually
to manually recall the
by pressing the appropriate memory
button. If the memory position is still
not recalling, see your dealer for
service.
Automatically Recalling Memory
Positions (Auto Memory Recall)
The Auto (Automatic) Memory
Recall feature automatically recalls
the current driver s previously stored
1 or 2 position when entering the
vehicle.
Depending upon the Auto Memory
Recall feature enabled in the vehicle
personalization menu, memory 1
or 2 positions are recalled in the
following ways:
To activate the recall when On -
Driver Door Open is selected in the
personalization menu, do one of the
following:
On vehicles with RKE, press
on the RKE transmitter and open
the driver door.
On vehicles with Keyless
Access, press the lock/unlock
button on the outside driver door