Toshiba 26HL84 Service Manual page 25

12. Removing the LCD and front bezel cover assembly
1) Remove the back cover. (Refer to Item 1.)
2) Remove the speakers. (Refer to Item 2.)
3) Remove the top shield bracket. (Refer to Item 3.)
4) Remove Power Module unit. (Refer to Item 4.)
5) Remove the Scaler board. (Refer to Item 5.)
6) Remove the D-Rewrite board and bracket. (Refer to Item 6.)
7) Remove the back plate. (Refer to Item 7.)
8) Remove the TU/AOUT,AV2 and Signal boards. (Refer to Item 8.)
9) Remove the Front/AV board. (Refer to Item 9.)
10) Remove the Power SW and LED/RMT boards. (Refer to Item 10.)
11) Remove the chassis frame. (Refer to Item 11.)
12) Remove 2 screws (BIDT2 3x10), then remove the key SW panel.
13) Remove 2 screws (BIDT2 3x10), then remove the Key SW board.
14) Disconnect the wire harness from the connector on the Key SW board.
15) Lift up the LCD slowly from the front bezel cover assembly toward to the arrow direction.
16) Remove 2 screws (PP 4x10), then remove the two bracket panels top.
Front bezel cover assembly
LCD
KEY SW board
– 25 –
Bracket panel top
PP 4x10
KEY SW panel
Harness
BIDT2 3x10
BIDT2
3x10