Log Placement - Napoleon BGD42N Installation And Operating Instructions Manual

34
6.5

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
Phazer logs and glowing embers, exclusive to Napoleon
tm
effect that is different in every installation. Take the time to carefully position the glowing embers for a maxi-
mum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become more
uniform as colour pigments burn in during the heat activated curing process.
Place the cutout in the bottom of log
A.
(W135-0297) behind the pilot assembly. Rest
the log against the back wall of the fi rebox.
Move the two small logs (W135-0298 &
B.
W135-0299) into position, lining up the studs
located on the burner with the holes on the
bottom of the logs.
Place the bottom of the left crossover log
C.
(W135-0300) onto the stud on the left side
of the log support. The top of the log should
rest in the pocket on the back log.
Place the bottom of the right crossover log
D.
(W135-0302) onto the stud on the right side of
the log support. The top of the log should rest
in the pocket on the left crossover log
(W135-0300).
W415-0777 / E / 08.26.13
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
WARNING
!
Fireplaces, provide a unique and realistic glowing
®
76.1A