Alcove Enclosure; Minimum Mantel Clearances - Napoleon BGD42N Installation And Operating Instructions Manual

30
5.3

ALCOVE ENCLOSURE

EN
NOTE: Recesses or alcoves above the appliance can be made as deep as desired provided the minimum
clearances to combustibles are maintained.
Non-combustible material can be used, provided the minimum clearances to combustible materials are applied.
The minimum enclosure volume must be increased by no less than the volume of the recess. This adjustment
can be made by increasing any or all of the height, width and depth of the enclosure.
5.4

MINIMUM MANTEL CLEARANCES

RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TO
OVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, MANTEL, FRONT, ETC.) ARE
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
Combustible mantel clearance can vary according to the mantel depth. Use the graph to help evaluate the
clearance needed. Curtains, above the appliance, must not be positioned lower than the 5" distance required
for the 2" combustible mantel. These same requirements apply to any combustibles protruding on either side
of the appliance.
W415-0777 / E / 08.26.13
RECESS OR
ALCOVE
AREA
APPLIANCE
WARNING
!
CLEARLY MAINTAINED.
HEAT RESISTANT TO PREVENT DISCOLOURATION.
ENCLOSURE
AREA
8" 203mm MANTEL
11"
279mm
9"
229mm
7"
178mm
5"
127mm
71.2
73.1
6" 152mm
4" 102mm
2" 51mm