Table of Contents
Advertisement
F-5
RANGER 9 / LN-25 WITH 42 VOLT REMOTE OUTPUT CONTROL MODULE CONNECTION DIAGRAM
14 PIN
AMPHENOL
CAUTION :
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
THE ENGINE WELDER OPERATING MANUAL.
N.A. USE POLARITY SWITCH TO SET FOR DESIRED ELECTRODE POLARITY. POSITION THE OUTPUT SELECTOR SWITCH TO A CV POSITION.
PLACE WELDER TERMINALS SWITCH TO "REMOTELY CONTROLLED" POSITION.
N.B. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
APPLICATIONS. SEE OPERATING MANUAL.
N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE OUTPUT CONTROL SWITCH IN "OUTPUT CONTROL REMOTE" POSITIION.
N.D. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
K915-1 AMPTROL ADAPTER FOR K799 HI-FREQ KIT
WARNING
TURN THE ENGINE OR POWER SWITCH
OF THE WELDING POWER SOURCE "OFF"
BEFORE CONNECTING OR DISCONNECTING
ELECTRIC SHOCK
PLUGS TO WELDING POWER SOURCE.
can kill
K963 HAND
AMPTROL
OR
K870 FOOT
AMPTROL
THIS ADAPTER ALLOWS AN AMPTROL TO OPERATE A K799
HI-FREQ KIT WHILE REMOTELY CONTROLLING THE
OUTPUT CURRENT OF A LINCOLN POWER SOURCE.
(THE POWER SOURCE MUST BE EQUIPPED WITH A
6-PIN REMOTE CONTROL AMPHENOL CONNECTOR.)
SEE THE HI-FREQ KIT AND POWER SOURCE INSTRUC-
TION MANUAL FOR INFORMATION ON PROPER SWITCH
AND CONTROL SETTINGS.
DIAGRAMS
WARNING
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
TO WORK
ELECTRODE
TO WORK
K915-1
AMPTROL
ADAPTER
6-SOCKET
RECEPTACLE
RANGER 9
Keep guards in place.
Keep away from moving parts.
Only qualified personnel should install,use
or service this equipment.
TO LN-25 INPUT
CABLE PLUG
K626-XX INPUT CABLE ASSEMBLY
ELECTRODE CABLE
TO WIRE FEED UNIT
6-PIN
PLUG
-
HI-FREQ KIT
INPUT POWER
5-PIN
PLUG
*
SEE INSTRUCTIONS INCLUDED WITH HI-FREQ
KIT FOR CONNECTION INFORMATION.
12-16-93
M17214
POWER SOURCE
+
*
BYPASS
CAPACITOR
KIT
ELECTRODE LEAD
*
WORK SENSE LEAD
K799 HI-FREQ KIT
S20909
F-5
*
*
4-19-96D
Advertisement
Table of Contents
