Fixing The Channels Or Dca Groups Of The Centralogic Section - Yamaha M7CL Owner's Manual

Fixing the channels or DCA groups of the Centralogic section

Fixing the channels or DCA groups of the Centralogic section
If desired, you can fix the channels or DCA groups controlled by the faders, [ON] keys, meters,
[CUE] keys, and [SEL] keys of the Centralogic section, and switch between groups of eight chan-
nels for control in the OVERVIEW screen.
In this case, the multifunction encoders will control a different set of eight channels than the
Centralogic section's faders and [ON] keys.
1
In the NAVIGATION KEYS section, press
the navigation key for the channels or DCA
group you want to fix in the Centralogic
section, and hold it down for two seconds
or longer.
The LED of the navigation key will blink. The blink-
ing indicates that the corresponding channels or DCA
groups are now fixed to the Centralogic section.
2
Press a navigation key (other than the
[DCA] key) to select the eight channels
you want to control in the OVERVIEW
screen.
The LED of the navigation key you selected in step 2
will light. The lit status indicates that the correspond-
ing channels can be controlled in the OVERVIEW
screen and by the multifunction encoders.
NOTE
• You cannot operate DCA groups in the OVERVIEW
screen using the multifunction encoders. For this rea-
son, pressing the [DCA] key in step 2 will have no
effect.
94
M7CL Owner's Manual
The following illustration shows the example of when
the DCA groups are fixed to the Centralogic section,
and INPUT channels 1–8 are controlled in the OVER-
VIEW screen.
Control INPUT
channels 1–8 in the
OVERVIEW screen.
Control DCA
groups 1–8.
3
As desired, use the navigation keys to
switch the group of eight channels con-
trolled by the OVERVIEW screen, multi-
function encoders.
4
To release the channels or DCA groups
that were fixed to the Centralogic section,
press the navigation key you operated in
step 1 once again, and hold it down until
the navigation key LED changes from
blinking to lit.
When the navigation key LED changes to being lit, its
channels or DCA groups will be assigned to both the
Centralogic section and the OVERVIEW screen.