Yamaha M7CL Owner's Manual page 48

Setting up to use the M7CL
5
In the STEREO/MONO MASTER section,
make sure that the [ON] key of the STEREO
channel is on, and raise the STEREO chan-
nel fader to 0 dB.
1
2
1 STEREO channel [ON] key
B
STEREO channel fader
6
Raise the fader of the currently selected
input channel to an appropriate volume.
In this state, you should now hear sound from the
speaker system that is patched to the STEREO chan-
nel.
If you don't hear sound, check whether the LR meters
are moving in the METER field of the function access
area.
[METER field of the function access area]
● If the LR meters are moving
It may be that the STEREO channel is not correctly
patched to the output jacks that are connected to
your speaker system. Check the output port patching
(→ p. 95).
● If the LR meters are not moving
It may be that the INPUT channel [ON] key is off.
Check the status of the [ON] key (→ p. 16).
48
M7CL Owner's Manual
HINT
• The signal being output from the STEREO channel can
also be monitored using headphones connected to the PHONES
OUT jack located below the front pad ( → p. 142).
7
To adjust the pan/balance of the signal sent
from the input channel to the STEREO bus,
turn the [PAN] encoder of the SELECTED
CHANNEL section.
When you turn the [PAN] encoder, the knob in the HA
field of the SELECTED CHANNEL VIEW screen
will move in tandem with the encoder.
8
Press the [SEL] key of another input chan-
nel, and adjust the pan/balance in the same
way.
When you press a [SEL] key to select another channel,
the channel shown in the SELECTED CHANNEL
VIEW screen will change accordingly.
● Using the Centralogic section
(settings for eight channels)
Here's how to use the Centralogic section and OVER-
VIEW screen to adjust the input level and pan/balance
sent to the STEREO bus for up to eight signals at a time.
1
Press a navigation key in the NAVIGATION
KEYS section so that the input channels
you want to control are assigned to the
Centralogic section.
The selected eight channels are shown in the OVER-
VIEW screen.
1
1 TO STEREO/MONO field
2
Make sure that in the TO STEREO/MONO
field of the screen, the ST symbol of each
channel is on (white characters on pink
background).
The ST/MONO symbol in the OVERVIEW screen
indicates the on/off status of the signal sent from that
input channel to the STEREO/MONO buses. If the ST
symbol is off (gray characters on a black background),
use the TO ST PAN/BALANCE field of the
SELECTED CHANNEL VIEW page to switch it on
(→ p. 47).