Using The Faders (Sends On Fader Mode) - Yamaha M7CL Owner's Manual

Sending the signal from an input channel to a MIX bus
D
PRE button
This button switches the position at which the signal is
sent from the input channel to a VARI type MIX bus.
The signal is sent from the post-fader position when
this button is off, and from the pre-fader position when
this button is on.
E
TO MIX SEND ON/OFF button
These are on/off switches for the signal sent from the
input channels to the MIX bus.
F
TO MIX SEND LEVEL knob
This screen shows the send level of the signal sent
from the input channels to the MIX bus. To adjust the
level, operate multifunction encoders 1–8.
If the send-destination MIX bus is set to stereo, the TO
MIX PAN knob (for a ST IN channel, the TO MIX
BALANCE knob) and TO MIX SEND LEVEL knob
are shown in this location.
G
ALL PRE button
This button selects PRE as the position from which
signals are sent from all input channels to VARI-type
MIX buses.
H
ALL POST button
This button selects POST as the position from which
signals are sent from all input channels to VARI-type
MIX buses.
6
Use the TO MIX SEND ON/OFF buttons to
switch the signals sent from the input chan-
nels to the currently selected MIX bus on/
off.
7
If necessary, use the PRE buttons to select
the location of the signal that is sent from
each input channel to a VARI type MIX bus.
HINT
• If the PRE button is on, you can also select PRE EQ (immedi-
ately before the attenuator) or PRE FADER (immediately
before the fader) for each MIX bus. This setting is made in the
BUS SETUP popup window ( → p. 212).
• The PRE button is not shown for FIXED type MIX buses.
8
Repeat steps 3–6 to adjust the send level
for other MIX buses in the same way.
64
M7CL Owner's Manual
Using the faders (SENDS ON
FADER mode)
Here's how you can use the faders of the top panel to
adjust the signal that is sent from all input channels to a
specific MIX bus.
1
Make sure that an output port is assigned
to each MIX bus to which you want to send
signals, and that your monitor system or
external effect etc. is connected to the cor-
responding output port.
For details on assigning an output port to a MIX bus
refer to p. 95. For details on connecting an external
device, refer to p. 39.
2
In the function access area, press the
SENDS ON FADER button.
The M7CL will switch to SENDS ON FADER mode.
The most recently selected group of MIX buses will be
assigned to the Centralogic section. The faders of the
INPUT section and ST IN section will move to the
send level values of each channel for the currently
selected MIX bus.
In SENDS ON FADER mode, the function access area
in the display will show buttons for selecting the send-
destination MIX bus.
1 MIX bus selection buttons
These buttons select the send-destination MIX bus.
The buttons will be joined if two MIX buses are set to
stereo.
3
Use the MIX bus selection buttons in the
function access area to select the send-
destination MIX bus.
HINT
• You can also select a MIX bus by using the navigation keys
and the [SEL] keys of the Centralogic section.
• If you once again press the MIX button selection button that is
currently selected, cue monitoring will be turned on for the
corresponding MIX channel. This method is convenient when
you want to monitor the signal that is being sent to the
selected MIX bus.
1