Kyocera Mita KM-4530 Service Manual page 215

• Removing the bypass upper paper feed pulley
7. Remove the spring, stop ring and bushing
from the bypass forwarding pulley retainer.
8. Disconnect the connector of the bypass
paper feed clutch and then remove the wire
from the edging and the wire saddle.
9. While pressing the bypass solenoid lever,
remove the bypass forwarding pulley retainer.
10. Remove the stop ring, gear, spring pin and
bushing on the front of the bypass paper feed
unit.
11. Pull the bypass paper feed shaft in the
direction of the arrow, and then remove the
bushing and bypass upper paper feed pulley.
* When fitting the bypass upper paper feed
pulley, put the blue end face to the front side
of the machine.
Connector
Bypass solenoid lever
Figure 1-6-23
Figure 1-6-24
Bypass upper paper
feed pulley
Bushing
Figure 1-6-25
Stop ring
Spring
Bushing
Bypass forwarding
pulley retainer
Spring pin
Stop ring
Bushing
Gear
Bypass paper feed shaft
1-6-11
2BC/D