2BC/D-1
9. Pull out drawer 3, remove the spacer.
10. Pull out drawer 4, remove the spacer.
* The lift or the guide may be deformed or damaged when
turns the main switch on with the spacers mounted.
Consequently, be sure to remove the spacers.
11. Open the DF and remove the piece of tape that
secures the original inverse cover.
12. Remove the paper from the platen.
Removing the pins holding light source units 1 and 2.
1. Remove the securing tape from the two pins on
the light source unit 1 and from the pin on the
light source unit 2, and then remove these pins.
1-3-4
Spacer
Spacer
Figure 1-3-5
Tape
Figure 1-3-6
Light source unit 1 pins
Light source unit 2 pin
Figure 1-3-7
Paper