Motorola MTP830 S Feature User Manual page 26

Feature User Guide
Table 2-6 Status Icons (cont'd.)
Icon
General Icons
2-10
Description
DMO Repeater Communication Mode — Displayed when the Repeater or GW + Rep
option in DMO Mode is selected. This icon has the following states:
• Solid — while the radio has detected the repeater (for example when the radio
receives a presence signal).
• Blinking — while the radio has not detected the repeater or during attachment.
• No icon — during a radio to radio and gateway call.
All Tones Off/Duplex and Simplex Ring Muted — Indicates that all alert tones are off in
the radio or both simplex ring volume is set to 0 and duplex ring volume is set to 0.
Simplex Ring Muted — Indicates that simplex ring volume is set to 0 and duplex ring
volume is set to more than 0.
Duplex Ring Muted — Indicates that duplex ring volume is set to 0 and simplex ring
volume is set to more than 0.
Vibrate On — Indicates that the radio vibrates to alert you of an incoming call.
Vibrate then Ring — Indicates that the radio vibrates and rings to alert you of an incoming
call.
Low Audio — Indicates that the audio mode is changed to low.
High Audio — Indicates that the audio mode is changed to high.
Earpiece Connected — Indicates that the earpiece is connected.
GPS — Indicates that a valid location coordinates are received.
RUI Logged on — Indicates that you are logged on into the radio.
RUI Pseudo Log On — Indicates that you are in pseudo logged on state.
RUI Packet Data — Indicates Pseudo Log On state when the Packet Data feature is
activated and the external device sets up data connection with the radio.
• No number — standby data session.
• Number 1, 2, 3, or 4 — indicates active data session with 25%, 50%, 75%, or
100% bandwidth.
RUI Packet Data — Indicates Pseudo Log On state when the Packet Data feature is
activated and the external device sets up data connection with the radio.
Battery Strength — Shows the charge of your battery.
-