Sharing A Workplace - Sennheiser D 10 series Instruction Manual

Sharing a workplace

Sharing a workplace
The headsets and base stations of the D 10 series are compatible with each
other. If, for example, you share a workplace, you can use one base station
with different headsets. The last headset paired with the base station can
be used without more ado.
Place the headset to be used into the magnetic holder of the base
station.
The Headset LED alternately flashes blue/red until the headset is
successfully paired with the base station. The Headset LED flashes
3 times blue and then goes off. You can now use the newly paired
headset.
If pairing has failed, the Link LED
off. Repeat the procedure.
Using the headset with a third party base station
(DECT-GAP telephone)
Place the headset at a maximum distance of 1 m from the third party
base station.
5 s
Simultaneously press and hold the headset's Link button and
Audio button for 5 seconds.
The headset switches to a special pairing mode and the Headset LED
alternately flashes blue/red.
Set the third party base station to a special pairing mode (see the
instruction manual of the third party base station). The default code
for the headset is "0000".
The headset pairs with the third party base station. If pairing is
successful, the Headset LED goes off.
If pairing is not successful within 60 seconds, the headset switches back
to standby mode.
To pair the headset again with a D 10 series base station:
Simultaneously press and hold the headset's Link button and
Audio button for 5 seconds.
The headset switches to a special pairing mode and the Headset LED
alternately flashes blue/red.
Place the headset into the magnetic holder of the base station. The
Headset LED flashes blue 3 times and then lights up blue. The base
station and the headset are paired.
on the base station lights up red or is
D 10 series
3x
| 32