Brother DCP-J315W Quick Setup Manual page 17

Wireless Network
Install the drivers & software (Mac OS X 10.4.11, 10.5.x, 10.6.x)
14
Before you install
a
Make sure your machine is connected to the
power and your Macintosh is ON. You must be
logged on with Administrator rights.
15
Install MFL-Pro Suite
a
Put the supplied installation CD-ROM into your
CD-ROM drive.
b
Double-click the Start Here OSX icon to install.
c
Choose Wireless Network Connection, and
then click Next.
d
The Brother software will search for the Brother
device in your wireless network. If the machine
is configured for your network, choose the
device you want to install, and then click Next.
Note
If your wireless settings fail, the Wireless Device
Setup Wizard will appear during the installation of
MFL-Pro Suite. Confirm your settings by following
the on-screen instructions. If you encounter this
failure, go to step 12-a on page 11 and setup the
wireless connection again.
e
Please wait, it will take a few seconds for the
software to install. After the installation, this
window will appear.
Choose your machine from the list, and then
click OK.
f
When this screen appears, click Next.
g
When the Brother Support screen appears,
click Close.
The installation is now
Finish
complete.
Note
• If you specify an IP Address for the machine,
you must set the Boot Method to Static by using
the control panel. For more information, see
the Network User's Guide on the
documentation CD-ROM.
• To use Image Capture on Mac OS X 10.6.x,
please install the CUPS Printer Driver, which
can be downloaded from the Brother Solutions
Center (http://solutions.brother.com/).
Macintosh
17