Transceiver Function Operational Parameters; Table 13 - Adaptable Parameters - Yaesu FT-450 User Manual

YAESU HF/50 mHz Transceiver FT-450 User's Manual
ID NAME FUNCTION
059 STBY BP Standby beep
060 TONE F Tone freq
061 TOT Turn off time
062* TUNER Tuner / ATAS
063 VOX DLY VOX delay
064* VOXGAIN VOX gain
Note 2 : 0=CWS sidetone,1=CW keyer spd,2=100KHz step,3=1MHz step,4=MIC gain,5=RF pwr
7.1

Transceiver function operational parameters

APO – default OFF out of
Selects the automatic power off time if no action taken.
BEEPTON – default 880 Hz out of 440, 880, 1760 Hz
Sets the tone of the transceiver beep alert to the user. The system uses these tones to signal
completion of an action or reaching certain values (as in EXT MENU)
BEEPVOL – default either FIX10 or LNK-8 our of range of FIX0 ~ FIX100 or LNK-50 ~ LNK+50
Sets the volume of the of the transceiver beep alert to the user. This is either a fixed volume or
one that is linked to and offset from the audio volume control. To toggle between a fixed volume
and a volume linked to the setting of the audio volume control, press the "F■" key.
CLK SFT – default OFF out of ON or OFF
Shifts the CPU clock frequency. Used to move a spurious response "birdie" if it interferes with
reception.
EMERGEN – default OFF out of ON or OFF
Set Alaska emergency spot frequency of 5167.5 kHz.
MEM GRP – default OFF out of ON or OFF
Reconfigures the 500 general purpose memory channels into 10 groups of 50 channels.
MEM-TAG –
Replace the memory channel name with your own 7 character tag. When you select a channel, the
number will display for two seconds before the tag displays.
PEAKHLD – default ON out of ON or OFF
Hold the S meter on its peak value for 0.5 seconds to make it easier to read.
QSPL-F – default +5 out of –20 ~ +20 kHz in 1 kHz increments
Offset frequency when using the one step Quick Split for transmit.
RFPOWER – default 100 watts out of
Set the maximum transmit power for the current band.
Table 13 – Adaptable Parameters
1 ~ 12 hours
5 ~ 100 watts in 1 watt increments
- 20 -
DEFAULT VALUES
OFF ON / OFF
88.5 Hz see Table 14 ( 67 ~ 254.1 Hz)
OFF OFF, 1 ~ 20 minutes
INT ATU ATAS. ext ATU, int ATU
500 msec 100 ~ 3000
50 1 ~ 100