Computer Aided Transceiver (Cat) Operation; Adaptation Of Cw Communication - Yaesu FT-450 User Manual

YAESU HF/50 mHz Transceiver FT-450 User's Manual
For PANEL – DSP, ATT/IPO, NB, AGC, METER, MODE, KEYER, CLAR, and STEP
For ALL – DSP, ATT/IPO, NB, AGC, MODE, KEYER, CLAR, VOX, STEP, the C.S functions
MONI, N/A, P/B, PLAY1, PLAY2, PLAY3, SWR, VCC, QSPL, DWN, FAST, and UP, and the
microphone buttons UP, DWN, and FAST.
PNL-C.S – default VCC out of
One of 53 functions shown in Table 9, Table 10, Table 11, or Table 12 can be assigned to the
"VOICE/C.S" key.
SELDIAL – default 100 kHz out of CWSTONE, CWSPEED, 100KHZ, 1MHZ, MICGAIN, RFPOWER
Sets the secondary function if the "DSP/SEL" knob is pressed.
TUNER – default INT ATU out of ATAS, EXT ATU, INT ATU, INTRATU, F TRANS
Sets the auto antenna and antenna tune.
M-TUNE – default ON out of ON or OFF
Allows copy and tuning from memory channel. Does not alter the memorized channel unless you
write it back.
SQL/RFG – default RF-GAIN out of SQL or RF-GAIN
Select the configuration for the panel "SQL/RF" knob.
7.3

Computer Aided Transceiver (CAT) Operation

CAT RTS – default ENABLE out of DISABLE or ENABLE
Enables or disables the request to send (RTS) port of the CAT jack.
CAT TOT – default 10 milliseconds out of
CAT time-out-timer for a single message. If a message exceeds this time, the input will be
disabled.
CATRATE – default 4800 bits per second out of
CAT baud rate.
SQL TYP – default OFF out of OFF, CTCSS encoder, CTCSS encoder/decoder – tone squelch
Selects the tone encoder and/or decoder mode.
7.4

Adaptation of CW communication

CW AUTO – default OFF out of OFF or ON
Enable key jack to automatically allow CW operation when USB or LSB selected.
CW BFO – default USB out of
Select CW carrier injection location. If AUTO is selected, the system will automatically use LSB
below 10 mHz or USB above 10 mHz)
CW DLY – default 250 milliseconds out of FULL or 30 ~3000 milliseconds
Table 9, Table 10, Table 11, or Table 12
10, 100, 1000, 3000 milliseconds
4800, 9600, or 38400 bits per second
USB, LSB, or AUTO
- 22 -