Interface Technical Reference - ZyXEL Communications ZyWall USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWall USG 300:

Table of Contents

Chapter 13 Interfaces

Table 82 Configuration > Network > Interface > Add (continued)

13.12 Interface Technical Reference

Here is more detailed information about interfaces on the ZyWALL.

IP Address Assignment

Most interfaces have an IP address and a subnet mask. This information is used to

create an entry in the routing table.

Figure 289 Example: Entry in the Routing Table Derived from Interfaces

Table 83 Example: Routing Table Entries for Interfaces

IP ADDRESS(ES)

100.100.1.1/16

200.200.200.1/24

Enter the priority of the gateway (if any) on this interface. The

ZyWALL decides which gateway to use based on this priority. The

lower the number, the higher the priority. If two or more gateways

have the same priority, the ZyWALL uses the one that was configured

Enter the maximum amount of traffic, in kilobits per second, the

ZyWALL can send through the interface to the network. Allowed

values are 0 - 1048576.

This is reserved for future use.

Enter the maximum amount of traffic, in kilobits per second, the

ZyWALL can receive from the network through the interface. Allowed

values are 0 - 1048576.

Click OK to save your changes back to the ZyWALL.

Click Cancel to exit this screen without saving.

ZyWALL USG 300 User's Guide