Citizen CL-S700 User Manual page 39

Top Menu Sub Menu
Menu Key Action
Interfaces RS-232C Baud
RS-232C Parity
RS-232C Length
RS-232C Stop bit
[RS-232C Stopbit]
RS-232C X-ON
IEEE1284
USB Device Class
[USB Device Clas]
USB VCOM Protocol
[VCOM Protocol]
Machine Model Number
Information
Boot Version
[Machine Info]
ROM Version
ROM Date
ROM CheckSum
Head Check
Print Counter
Service Counter
Sensor Monitor
Option Interface
[Option I/F]
Test Mode Print Pattern
Head Check
Default Menu
Enters Menu Enters Menu
Repeat Last Set
Repeat Last One
9600 1 15200
57600
38400
19200
9600
4800
2400
None None
Odd
Even
8 bits 8 bits
7 bits
1 bit 1 bit
2 bits
On Yes On Yes
Off No
On On
Off
Printer Printer
VCOM
Auto Auto
DTR
X-ON
– CL-S***
– *.*
– ********
– **/**/**
– ****
– OK
NG
– ****.*** km
– ****.*** km
– *.* V
– None
LAN
Current Config Current Config
Global Config
Sample
No Yes
No
39
Printer Operation
Mode Settings
[Datamax Emulation]
Remarks
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Last Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the final page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least 4
seconds in order to enter the Menu Setup
Mode when setting the "Repeat Last Set" or
"Repeat Last One" menus.
Setting the baud rate of the serial interface.
• All settings related to the interface are
enabled after the power is reconnected.
Setting the communication parity for the
serial interface.
Setting the character length for the serial
interface.
Setting the stop bit for the serial interface.
Selectively setting the X-ON flow control of
the serial interface.
Setting both direction of the Centro
Interface.
Selects the USB device class.
Selects the protocol (flow control) when
operating USB VCOM.
Displays the model name.
Displays the boot version.
Displays the ROM version.
Displays the date the ROM was prepared.
Displays the check sum of the ROM.
Displays the results of the head check.
Displays the print counter.
Displays the service counter.
Displays the sensor level.
Displays the presence/absence of the
optional interface.
Executes the test pattern.
Executes head check.