Menu Setting - Citizen CL-S700 User Manual

Menu Setting Table
Page Setup Menu - allows you to change settings related to the media or print quality.
System Setup Menu - allows you to change settings for the printer hardware and basic control systems.
After Print Menu - changes how the printer reacts after the label has been printed.
Interfaces - changes interface parameters such as baud rate.
Machine Information, Test Mode - allows you to check and/or print test pages and information about the printer.
Global Config menu - allows you to switch between 3 complete 'config sets' contained within the printer.

Menu Setting

Press the MENU key in print possible status to enter MENU Setup Mode. Use the keys on the operation panel
according to the LCD display to setup the printer. The contents that can be setup on the printer are shown
below. And the items that are actually displayed on the LCD are shown in [ ].
7 Datamax Emulation
Top Menu Sub Menu
Page Setup Print Speed
Print Darkness
Darkness Adjust
[Darkness Adj]
Print Method
Continuous Media
Length
[Cont Media Len]
Vertical Position
[Vertical Pos]
Horizontal Shift
[Horizontal Shif]
Vertical Image Shift
[Vertical Image]
Sensor Select
Media Sensor
Small Media
Adjustment
[Small Media Adj]
Small Media
Length
[Small Media Len]
Symbol Set
System Setup Sensor Monitor
Sensor Level
Paper End Level
Cover Open Sensor
[Cover Sensor]
Buzzer Select
Default Menu
7 IPS 2 to 10 IPS
12 00 to 30
00 -10 to 10
TT TT (Thermal Transfer) Selection of Thermal Transfer (ribbon) or
DT (Direct Thermal)
4.00 inch 0.25 to 32.00 inch
101.6 mm 6.4 to 812.8 mm
0.00 inch -1.00 to 1.00 inch
0.0 mm -25.4 to 25.4mm
0.00 inch -1.00 to 1.00 inch
0.0 mm -25.4 to 25.4mm
0.00 inch 0.00 to 32.00 inch
0.0 mm 0.0 to 812.8mm
Rear Adj Sensor Rear Adj Sensor
Front Fixed Sen
See Through See Through
Reflect
None
Off On
Off
1.00 inch 0.25 to 1.00 inch
25.4 mm 6.4 to 25.4mm
PM 50 symbols
– –
1.4 V 0.0 V to 3.0 V
2.80 V 0.01 V to 3.00 V
Off On
Off
Exec/Err Exec/Err
All
Error
Key
None
37
Printer Operation
Mode Settings
[Datamax Emulation]
Remarks
Printing speed setting.
Adjusting print darkness.
Fine adjustment of darkness commands.
Direct Thermal.
Setting media length of continuous media.
Lower level = during mm mode.
Adjusting printing start position.
Adjusting horizontal image position.
Adjust the off set value in vertical when
mapping data on the printer RAM.
Selecting front fixed/rear adj. sensor.
Selecting media sensor.
Setting for small media.
Setting media length for small media.
Setting symbol set.
Displays level of sensor that is currently
selected.
Selects threshold of the sensor.
Sets the paper end level.
Sets the cover open sensor.
Setting buzzer sounding conditions.