Table of Contents
Advertisement
Configuring the phone via the Web configurator
Changing the base settings, registering handsets
You can use the Web configurator to:
u
Switch the base to registration mode to register handsets to the base. This set-
ting corresponds to pressing and holding the registration/paging button on the
front of the base.
u
Activate/deactivate Eco Mode or Eco Mode+. For Eco Mode see
u
Change the system PIN
u
Activate and deactivate the LED for the registration/paging button on the front
of the base. See
u
Activate/deactivate the display of VoIP status messages on your handset.
The base settings are on the Web page
Settings
Updating firmware for the base/restoring firmware updates,
activating/deactivating automatic updates
You can start firmware updates and downgrades via the Web page:
Settings
Regular updates to the base firmware and the provider profile for your VoIP connec-
tions (general provider data) are made available on an Internet configuration
server. You can download these updates onto your base as required. The URL for
this server is stored in the base.
You have the following options:
u
Starting a firmware update
If a new version of the firmware is available, this is downloaded to the base and
the base is restarted. A firmware update lasts around six minutes. The duration
also depends on the bandwidth of your DSL connection.
u
Enabling/disabling the automatic version check
When the version check is enabled, the phone checks on a daily basis whether
the Gigaset configuration server has a new version of the phone firmware.
If the telephone is not connected to the Internet at the time when the check is
to be performed (e.g., because the router is disabled), the check is performed as
soon as the phone is reconnected to the Internet.
If a new version is available, a message to this effect is shown on the display of
the registered handsets. You can start the update of the firmware on one of the
handsets.
u
Downgrading firmware
You have the following options:
– You can reload the firmware version that was loaded before the last update
on the base.
– You can reload the firmware version that was loaded by default onto the
phone.
The selected firmware is reloaded onto the phone and the current firmware is
overwritten.
142
¢
(
page 9
for the meaning of the LED.
¤
¤
Management
Miscellaneous
¤
¤
Management
Firmware Update
page 107)
for your phone.
page
93.
Advertisement
Chapters
Table of Contents
