Power Connector Cable - HP Pavilion 14 Notebook PC Maintenance And Service Manual

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. Optical drive (see
c. Top cover (see
d. System board (see
Remove the power connector board:
NOTE: One of the power connector bracket screws was removed when removing the system board.
1. Turn the system board upside down, with the front toward you.
2. Remove the Phillips P2.5x4.0 screw from the power bracket (1).
3. Remove the power bracket (2).
4. Release the power connector from the clip built into the system board (3).
Battery on page 29), and then remove the following components:
Service door on page 30)
Optical drive on page
Top cover on page 39)
System board on page
32)
49)
Component replacement procedures
Spare part number
767246-001
57