How To Renew The Element On The Secondary Fuel Filter - Perkins 1106 Series User Handbook Manual

N40469
Figure 17
How to renew the element on the
secondary fuel filter
Warning! Fuel leaked or spilled onto hot surfaces
or electrical components can cause a fire. To help
prevent possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Note: Refer to, "Cleanliness of Fuel System
Components" in the Installation Manual for detailed
information on the standards of cleanliness that must
be observed during ALL work on the fuel system. It
is important to maintain extreme cleanliness when
working on the fuel system, since even tiny particles
can cause engine or fuel system problems.
It is important to maintain extreme cleanliness when
working on the fuel system, since even tiny particles
can cause engine or fuel system problems.
Note: Ensure that the engine is stopped before any
servicing or repair is performed.
After the engine has stopped, you must wait for 60
seconds in order to allow the fuel pressure to be
purged from the high pressure fuel lines before any
service or repair is performed on the engine fuel lines.
If necessary, perform minor adjustments. Repair any
leaks from the low pressure fuel system and from the
cooling, lubrication or air systems. Replace any high
pressure fuel line that has leaked.
Ensure that all adjustments, maintenance and repairs
are performed by authorized personnel that have the
correct training.
Typical example
1. The engine can have the ability to auto start.
Ensure that the power supply is isolated before
any service or repair is performed.
2. Turn the fuel supply valve to the OFF position
before performing this maintenance.
3. Use a chain wrench in order to remove old canister
(2).
4. Lubricate the 'O' ring seal (1) with clean engine oil
on the new canister. Install the new canister.
Caution: Do not use filter where the wrapping is
damaged. Do not prefill.
5. Spin on the canister until the 'O' ring seal contacts
the sealing surface. Then rotate the canister 3/4
of a full turn. Do not use a tool in order to install
the canister.
5. Open the fuel supply valve. Remove the container
and dispose of the fluid in a safe place.
Chapter 5
Page 37