Auxiliary Control Panel Overview - Perkins 1106 Series User Handbook Manual

N40469
Figure 2

Auxiliary control panel overview

The auxiliary control panel shown in figure 2 is
used on craft which have an extra control point. The
switches are protected from the entry of water, but if
the control panel is in an exposed location, it should
be protected by a cover when not in use.
Below is a description of the instrument and switches
on the auxiliary panel.
1. Tachometer - indicates the engine speed.
2. Engine hours/fault code display - displays
accumulated hours and fault codes.
3. Warning light
4. Warning lamp - indicates a fault signal.
5. Engine crank - turns the engine over.
6. Keyswitch on/off - energises the panel.
7. Diagnostic lamp - indicates active diagnostics
codes.
8. Engine stop switch - stops the engine.
9. Panel illumination - ten positions of brightness.
10. Warning lamp - overspeed.
Caution: If the audible warning device operates,
the warning light(s) on the relevant main panel will
indicate the engine affected. Reduce the speed of
the engine affected to idle and, if necessary, stop the
engine.
Chapter 3
Page 11