Engine Fluids; Fuel Specification; Low Temperature Fuels - Perkins 1106 Series User Handbook Manual

N40469

Fuel specification

To get the correct power and performance from your
engine, use good quality fuel. The recommended fuel
specification for Perkins engines is indicated below:
Cetane number .........................................45 minimum
Viscosity ...........................2.0/4.5 centistokes at 40
Density.......................................... 0,835/0,855 kg/litre
Sulphur .................................0.2% of mass, maximum
Distillation ..............................................85% at 350
Cetane number indicates ignition performance. A
fuel with a low cetane number can cause cold start
problems and affect combustion.
Viscosity is the resistance to flow and engine
performance can be affected if it is outside the limits.
Density: A lower density reduces engine power, a
higher density increases engine power and exhaust
smoke.
Sulphur: A high amount of sulphur (not normally
found in Europe, North America or Australasia) can
cause engine wear. Where only high sulphur fuels
are available, it is necessary to use a highly alkaline
lubricating oil in the engine or to renew the lubricating
oil more frequently, see the table below.
Percentage of sulphur
in the fuel (%)
<0.5
0.5 to 1.0
> 1.0
Distillation: This is an indication of the mixture of
different hydrocarbons in the fuel. A high ratio of
light-weight hydrocarbons can affect the combustion
characteristics.

Low temperature fuels

Special winter fuels may be available for engine
operation at temperatures below 0
a lower viscosity and also limit the wax formation in the
fuel at low temperatures. If wax formation occurs, this
could stop the fuel flow through the filter.
If you need advice on adjustments to an engine setting
or to the lubricating oil change periods which may be
necessary because of the standard of the available
fuel, consult your nearest Perkins distributor.
Chapter 4

Engine fluids

C
O
C
O
Oil change interval
Normal
0,75 of normal
0,50 of normal
C. These fuels have
O
Page 19