Chapter 5
6. Rotate the bowl counter clockwise in order to
remove the bowl. Remove 'O' ring seal (3). Clean
the bowl.
7. Use a chain wrench in order to remove old canister
(2).
8. Lubricate the 'O' ring seal (1) with clean engine oil
on the new canister. Install a new canister.
Caution: Do not prefill.
9. Spin on the canister until the 'O' ring seal contacts
the sealing surface. Then rotate the canister 3/4
of a full turn. Do not use a tool in order to install
the canister.
9. Install a new 'O' ring seal into the bowl. Lubricate
'O' ring seal (3) with clean engine oil. Install the
bowl onto the new canister. Tighten the bowl
securely. Install the wiring harness to the sensor.
9. Open the fuel supply valve. Remove the container
and dispose of the fluid in a safe place..
Page 36
N40469