To Alter Buttonhole Stitch Width And Density - Janome memory craft 2400 Instruction Book

n
u
W5.0 L0.4
q w
i
o
! 0
! 1
e r
Sensor Buttonhole, cont'd
n Remove the fabric and place a pin just before the
bartack at each end to prevent accidentally cutting
bartacks.
Cut the opening with the seam ripper.
When buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
Note:
Make sure there is no gap between the slider and the spring
holder. If there is a gap, the length of the rows will be
different, as shown.
i
Slider
o
There shoud be no gap.
!0
Spring holder
!1
Uneven stitch results

• To Alter Buttonhole Stitch Width and Density

[To change the stitch width]
The stitch width key controls the stitch width.
The pre-set buttonhole widths are: square buttonhole 5.0,
rounded buttonhole 4.0, keyhole buttonhole 7.0.
Press "+" or "–" to adjust the stitch width of the entire
buttonhole, ranging between 2.5 to 7.0 depending on the
selected buttonhole.
q
Narrower width by pressing "–".
w
Wider width by pressing "+".
[To Change Stitch Density]
The stitch length key controls the stitch density.
The pre-set density is 0.4.
Press "+" or "–" to adjust the stitch density of the entire
buttonhole between 0.2 to 0.8 depending on the selected
buttonhole.
e
Denser stitch by pressing "–".
r
Coarser stitch by pressing "+".
23