Table of Contents
Advertisement
q
w
t
r
z
q
e
w
r
x
c
t
n
u
e
v
b
y
i
4-Step Buttonhole
Machine setting
q Stitch pattern:
w Stitch width:
4 – 5
e Stitch length:
0.5 – 1
r Thread tension: 1 – 5
t Presser foot:
Sliding buttonhole J or
Buttonhole foot B
z Set the pattern selector dial at "
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
Draw both of needle and bobbin thread to the left.
Move the slider toward you so that the top mark w
on the slider meets the start mark q.
q Start mark
w Top mark
e Needle thread
r Bobbin thread
NOTE:
The scale on the slider is engraved in centimeters.
x Sew forward until you reach the front marking of your
buttonhole. Stop sewing at a left stitch.
c Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing at a right stitch.
v Raise the needle to its highest position.
Set the pattern selector dial at "
needle reach the back marking of the buttonhole.
b Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing. Set the stitch length dial to "0" and
the pattern selector dial at straight sewing.
Sew a few locking stitches.
n Raise the needle and presser foot. Remove the fabric
from the machine and cut the sewing thread. Insert a
pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
t Pin
y Seam ripper
To adjust buttonhole stitch density:
Set the stitch length dial between "
buttonhole stitch density.
u Denser buttonhole
i Coarser buttonhole
48
".
". Sew 5 stitches,
". Sew until the
". Sew 5 stitches,
" to adjust the
Advertisement
Table of Contents
