Section Ii Getting Ready To Sew; Connecting Machine To Power Supply; Controlling Sewing Speed - Janome memory craft 2400 Instruction Book

q
y
4
r
w
t
e

SECTION II GETTING READY TO SEW

Connecting Machine to Power Supply

Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
For Use of the Foot Control:
* Turn off the power switch, and insert the foot
control plug q and the machine plug w into the
machine and the power supply plug e into the
wall, in this order.
q Foot control plug
w Machine plug
e Power supply plug
For Your Safety:
1. While in operation, always keep your eye on the
sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
2. Always turn off the power switch and unplug from the
power supply:
* When leaving the machine unattended.
* When attaching or removing parts.
* When cleaning the machine.
3. Do not place anything on the foot control, except in use.
Operating Instructions:
The symbol "0"of a switch indicates the "off " position
of a switch.
For appliances with a polarized plug (one blade wider
than the other ).
To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model 21249 use with Sewing Machine
Model MC 2400.
(For U.S.A. market only).

Controlling Sewing Speed

Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
r Power switch
t Power supply cord
y Foot control