Installing the connection set and collector temperature sensor
Observe the following when installing
the locking ring fitting:
&
All pipes must be cut at a right angle
and deburred.
&
Push the union nut and the locking
ring onto the pipe and lightly lubri-
cate the threads with oil.
A Flow connection
B Return connection
&
Push the pipe into the locking ring
fitting as far as it will go.
&
Initially turn the union nut by hand,
then tighten with an open ended
spanner by a further ¾ turn.
Never fit annealed copper pipes onto
the locking ring fittings.
C Swaged connection
D Type plate
49