Fitting The Connection Set And Collector Temperature Sensor; Components - Viessmann Vitosol-F Installation Instructions Manual

Fitting the connection set and collector temperature sensor

Components

Connection set
zP zQ
Fig. 17
Connection pipe (short)
zP
Connection pipe (long)
zQ
Plug
zW
Locking ring fitting (angled),
zE
Sensor well set
uP uQ
Fig. 18
Support sleeve
uP
Locking ring fitting (tee),
uQ
Sensor well
uW
Observe the following when installing the locking ring
fitting:
All pipes must be cut at right angles and deburred.
■
■ Push the union nut and locking ring onto the pipes.
Lightly lubricate the threads with oil.
■ Push the pipe into the locking ring fitting as far as it
will go.
Initially tighten union nut by hand, then tighten with
■
an open-ended spanner by a further
!
■ Please note
Connection pipes and plugs must not display
any damage.
Lubricate O-ring seals only with the special
valve grease supplied.
zE
zW
22 mm, 90°
7
uW uE uR
22 mm
7
revolution.
¾
zR
zT zZ
Profile clip
zR
Support sleeve
zT
Special valve grease
zZ
Strain relief fitting
uE
Thermal insulation
uR
Never fit annealed copper pipes onto the locking ring
fittings.
19