Call Channel Programming; Channel Name Programming - Icom IC-M423 Instruction Manual

4
BASIC OPERATION

Call channel programming

■
You can program the Call channel with your most often-used
channel in each channel group for quick recall.
Select the desired channel group (INT, USA or CAN) to be
q
programmed. (p. 10)
Hold down [16/C] for 1 second to select the Call channel of
w
the selected channel group.
• "CALL" and the Call channel number appear.
Hold down [16/C] again for 3 seconds (until a long beep
e
changes to 2 short beeps) to enter the Call channel pro-
gramming mode.
Rotate Dial or push [
r
Push [ENT] to program the displayed channel as the Call
t
channel.
• Push [CLEAR] to cancel.
13
∫](CH)/[√](CH) to select a channel.

Channel name programming

■
Each channel can be assigned a unique alphanumeric ID of
up to 10 characters.
Capital letters, 0 to 9, some symbols (! " # $ % & ' ( ) * + , – .
/ [ \ ] ^ _ : ; < = > ?) and a space can be input.
Push [ ∫](CH) or [√](CH) to select a channel.
q
• First, cancel the Dualwatch, Tri-watch or Scan function, if acti-
vated.
Push [NAME] to open the channel name programming
w
screen.
• A black box is displayed on the first character.
Enter the desired channel name in the following manner:
e
• Select a desired character using Dial, or [∫]/[√]/[Ω]/[≈].
• Push [ENT] to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT].
• Select "SPACE," then push [ENT] to input a space.
• Select "DELETE," then push [ENT] to delete a character.
• Push [CLEAR] to cancel and return to the previous screen.