User Set Mode; Priority A Channel Selection; Emergency Call - Icom IC-F3021T/S Instruction Manual

3
BASIC OPERATION
■ User set mode
User set mode is accessed at power ON and allows you to
set seldom-changed settings. In this case you can "custom-
ize" the transceiver operation to suit your preferences and
operating style.
Entering the user set mode:
q While pushing and holding [Side2] and [Side3], rotate
[VOL] to turn the power ON. Then, push and hold [P0] for 1
sec. to enter user set mode.
w Push [P0] several times to select the appropriate item.
Then push [CH Up] or [CH Down] to set the desired level/
condition.
• Available set mode functions are Backlight, Beep, Beep Level,
SQL Level, Mic Gain, Battery Voltage, Signal Moni and Lone
Worker.
e Rotate [VOL] to turn the power OFF to exit user set mode.
N OTE: User set mode is also available via a programmable
function key. Refer to "USER SET MODE KEY." (p. 9)
■ Priority A channel selection
Depending on the presetting, the Priority A channel is selected
each time the transceiver power is turned ON.
14
■ Emergency Call
When [Emergency] is pushed for the specified time period*,
the emergency signal is transmitted once, or repeatedly, on
the specified emergency channel.
A repeat emergency signal is automatically transmitted until
the transceiver receives an acknowledgement signal, or you
turn the transceiver power OFF.
When no emergency channel is specified, the signal is trans-
mitted on the previously selected channel.
If you want to cancel the emergency call, push and hold
[Emergency] again before transmitting the call.
If your transceiver is programmed for Silent operation, you
can transmit an Emergency call without the beep sounding
and the LED indicator lighting.
IMPORTANT: It is recommended to set an emergency
channel individually to provide the certain emergency call
operation.
* Depending on the presetting. Ask your dealer for details.