Hitachi DZ-BD7HA Service Manual page 39

Troubleshooting > Messages and Troubleshooting
Message
Disc includes protected
scenes.
Delete scenes?
YES NO
Disc is full.
Cannot add control info.
Disc is not formatted.
Format the Disc now?
YES NO
(When using a DVD-RW: If
you select "YES" with the
above message, the message
shown below will appear.)
Disc format.
Select record format.
VR mode VF mode
Disc must be fi nalized before
it can be played on another
device.
Drive overheat.
Please retry later.
Dubbing is not complete
End of card
Cause/condition for
message to appear
Appears if the loaded DVD-RAM/DVD-
RW(VR) has a program (scene) that is
write-protected by the software write-
protect function, which is effective in
program units. Although the camcorder
is equipped with a software disc-protect
function that is effective for disc units,
it does not comply with software write-
protect for program units.
The DVD Forum defi nes two types of
software protect for DVD-RAM/DVD-
RW(VR): disc units and program units.
Appears if the number of scenes on play
list exceeds the upper limit while control
information is being added.
[Refer to *1 page 4-11]
Appears when a brand-new BD-RE/
BD-R/DVD-RW was loaded.
Appears when reading or writing from/to
recorded fi le cannot be performed be-
cause the DVD-RAM is dirty.
May appear when a BD/DVD format-
ted and recorded on a device other than
camcorders is loaded.
Appears when an unformatted
BD-RE/BD-R/DVD-RAM/DVD-RW or
one initialized (other UDF2.0) on PC is
loaded.
Also appears if user rejects partial re-
pair or total repair of video fi le.
Appears if a non-fi nalized BD-R/
DVD-RW(VF)/DVD-R is removed.
Appears when the temperature inside
the camcorder, or the temperature of
BD/DVD, is too high, and normal opera-
tion cannot be executed.
Appears when dubbing has failed.
Appears when the recording capacity of
card has reached the limit during record-
ing.
4 - 6
Troubleshooting
Release the write-protect using the
device that has the software write-
protect function for program units,
or choose "YES" and designate it to
delete the scenes.
Delete any unnecessary scenes, or
combine several scenes, and then
operate the camcorder.
When recording on the camcorder,
choose "YES/VR Mode/VF Mode" and
designate it.
Refer to "4-3-5 Cleaning BD/DVD
and optical pickup" and clean the
BD/DVD. Or replace the BD/DVD.
Use a PC, etc. to check the contents
on BD/DVD.
When initializing it (deleting all
recorded data), choose "YES" and
designate it.
Choose "NO" and designate partial
repair or total repair. When initial-
izing it (deleting all recorded data),
choose "YES" and designate it.
Finalize the BD-R/DVD-RW(VF)/
DVD-R before playing it back on
another BD/DVD device.
Set the power switch to "OFF" with
the BD/DVD loaded, and then leave
the camcorder in a well-ventilated
place until the inside temperature
decreases.
Retry dubbing. Replace the BD/DVD.
Replace the card, or delete
unnecessary stills.